Tradeoffs Between Active Control and Identification of Structural Systems
This paper explores the tradeoffs between structural identification and structural control in a quantitative manner. Through the intemediary concept of an optimal input, it is shown that...
Rock Excavation with Boom Mounted Hydraulic Impact Hammers
A hydraulic demolition hammer mounted on a common backhoe or excavator carrier has gained world wide acceptance in the construction industry as a viable alternative to blasting. This paper...
Fracturing of Rock Using Expansive Soundless Chemical Demolition Agents
The theoretical principles of the action of expansive soundless chemical demolition agents are presented. The procedure for using these demolition agents are briefly outlined. Differences...
Barrier Beach Water Table Management
The solution to the water table elevation within a barrier beach, subject to the assumptions of a homogeneous and isotropic phreatic aquifer, is an ellipse with its long axis oriented...
The Coastal Breach at Nauset Beach, Chatham, Massachusetts?A Case Study
Nauset Beach, a barrier spit separating Pleasant Bay from the Atlantic Ocean at the town of Chatham, Massachusetts on Cape Cod, breached in a severe storm on January 2, 1987. The breach...
Scenarios for Land Use on Delaware Barrier Beaches
Design criteria developed from tenets of the industrial-scientific world view emphasized capital-intensive use of barrier beaches for maximum economic productivity, whereas bioregional...
Loss of Carrying Capacity in Pipes?Transporting Softened Water with High pH
The increase in pipe roughness and loss in carrying capacity for water mains carrying high pH water is documented with over 20 field tests conducted in Austin, Texas. The data show that...
A Method for Design and Evaluation of Rapid Sand Filters Treating Secondary Effluents
The information presented in this paper provides a framework for analysis of rapid sand filter performance. Process variables are quantitatively related to filter design variables in a...
Design and Construction of Slow Sand Filters
The belief that large area requirements are necessary is based on old concepts and contemporary engineering designs that overstate area requirements. Large area requirements result from...
Proposal for Combining Expert Systems and Canal Design
Expert Systems can be combined with a computer aided design methodology to develop a cost effective canal system. The System should consider a feasible set of design alternatives to satisfy...
Flood Impact and Management of Levees in Tennessee
The construction of private levees is causing flooding and erosion problems along several tributary rivers in West Tennessee. The severity of these problems is recognized by the State...
Impact of Polders Upon Flood Stage of Atrai River
A mathematical model study, using System 11 model of the Danish Hydraulic Institute, is made to assess the impact of flood control polders upon flood level of Atrai River in Bangladesh....
Development of the Hydrology Criteria Manual for Harris County, Texas
The Harris County Flood Control District (HCFCD) was created in 1937 with the primary objectives of reducing potential damages from flooding in the Harris County area and of providing...
Modeling a Multiple Well Groundwater Supply System
The paper is concerned with the simulation of existing groundwater supply systems. This encompasses the delivery of the groundwater from the wells to the water treatment plant, including...
Pressure Relief Design Around Pumping Plants
Hydraulic transient protection for an irrigation pipeline pump station can include optimized operating procedures, or design of surge relief equipment such as surge relief valves, and...
Proper Use of Effective Flow Boundaries
The determination of the appropriate effective flow boundaries is an important factor in the hydraulic modeling of the flow regime of a stream. It is especially critical in areas with...
Locating and Sizing Air Release Valves on Irrigation Systems
This writing is directed to persons involved in irrigation systems and describes the usage of air release and vacuum valves. Principles described are applicable to many other piping systems,...
Simulation Model for Economic Irrigation Project Planning and Design
The principle design parameters considered are: water supply configurations (quantity, source and storage); shapes and sizes of the area to be served; on-farm irrigation techniques; cropping...
A Tale of Two Subjects: Modern Physics and River Mechanics
The Einsteins, father and son, made some of the greatest contributions to physics and to river mechanics, respectively. The modern phases of these two subjects are of roughly equal age....
Advances in Computational Mobile-Bed Hydraulics
A new conceptual approach to one-dimensional mobile-bed simulation is briefly described, along with two demonstrative examples. The approach is based on fully coupled solution of the unsteady...
Return to search