Longitudinal Surface Profiles of Granular Debris Flows
Longitudinal surface profiles of granular material flowing down an inclined plane were studied by means of theoretical analysis and laboratory experiments. There are two driving forces...
Resistance Consisting of Both Viscous Force and Dispersive Force
A set of specially designed experiments have been carried for studying the resistance of a flow consisting of water and both fine and coarse particles. The viscous force caused by fine...
Sediment Transport Characteristics of Hyperconcentrated Flow with Suspended Load
In this paper, based on the analysis of the ovserved data, a set of theories is proposed of the transport of heper-concentrated sediment, the basic points of which are: (1) The hyperconcentrated...
Stable Channel Analytical Design Method
The Flood-Control Channels Research Program is being conducted at the US Army Engineer Waterways Experiment Station to develop systematic methods for design of stable channels for small...
Can Erosion Control Meet Regulatory Standards?
An erosion control design method for rainfall/surface erosion is presented that enables the designer to determine design loads and the resulting erosion control requirements. Design loads...
Hydraulic Modeling of Flow Control Gates
Flow control gates are subject to complex hydrodymanic loadings, which may in many cases only be predicted through investigation on a physical hydraulic model. Scaling of gate models,...
Advances in Pipeline Materials
Pipelines transport water, storm run-off, process wastes, petroleum, natural gas, slurries, solids, sewage, steam and other fluids either by gravity or under pressure. Pipelines are also...
Wood Variability Effects in Structural Assessment
Engineers evaluating the load carrying capacities of in-service wood structures commonly determine the strength and stiffness properties of structural wood members by various assessment...
Bond Performance of Reinforcing Bars Embedded in Fiber Reinforced Concrete and Subjected to Monotonic and Cyclic Loads
The primary variables investigated were fiber content and loading history. The reinforcing bar size was ASTM #5. Steel fibers with hooked ends were used with four fiber contents, namely;...
Rate Effects on Fracture of Concrete
An analytical and experimental investigation of mode I (tensile and mixed mode (combined tensile and shear) fracture of concrete subjected to impact loading was conducted. The rate of...
Creep of Polycrystalline Ice
This paper discusses the extension of creep models for polycrystalline ice to include the effects of a non-monotonic loading history. Attention is focussed on cyclic loading since it is...
Repair of an Improperly Detailed Masonry Facade: A Case History
The masonry facade of an 18-story condominium building was constructed with an inconsistent pattern of shelf angle supports, marginal lateral restraints and without any horizontal control...
Durability of Fly Ash Concrete in the Marine Environment
This paper presents the experimental investigation of durability of air-entrained fly ash concrete in the marine environment. The findings indicate that the deterioration rate of durability...
Effect of Fly Ash on the Microstructure and Durability of Concrete
The influence of fly ash on the microstructure and durability of concrete was investigated. It was found that the use of 50% fly ash in concrete reduced greatly its resistance to freezing-and-thawing...
Permeability Effects on the Sulfate Resistance of Concrete
A laboratory study was conducted to determine the effect of permeability on the sulfate resistance of concrete containing fly ash. Concrete specimens were moist cured for 7 and 100 days...
Time-Dependent Behavior of FRP Lintels
This paper describes an experimental investigation into the short-term and long-term behaviors of two types of T-shaped lintels made of fiber-glass reinforced plastic with polyester or...
Early-Time Strength and Elastic Modulus of Concrete With High Proportions of Fly Ash
Compressive strength and elastic modulus data are presented for four concrete mixtures with ratios (by volume) of Class C fly ash to total cementitious materials (portland cement plus...
Parameter Study of Stresses in Mass Concrete Using Two Fly Ash Mixtures
Finite-element modeling of the incremental construction procedure for mass concrete structures has been used to study the effects of three mechanical properties on thermal stresses. Material...
Laboratory Fatigue Investigation of a GRP Bridge
A fatigue study of a 4.9 m glass-reinforced plastic bridge indicated a resistance to 1.6 million cycles of load without extensive damage to joints or elements. Viscoelastic creep occurred...
Size Effect in Concrete Structures and Influence of Loading Rate
The size effect law models the influence of the dimensions of the structure or specimen on the failure stress. This model can be used to quantify the brittleness of failure, and determine...
Return to search