Interpretation of CPT Data for Design of Earth Dams Near Tehachapi, California
The Static Cone Penetration Test (CPT) was used to obtain needed geotechnical information for design and construction of two small earth dams near Tehachapi, California. The basic CPT...
Analysis of Liquefaction Potential by Insitu Testing
This paper describes the results of insitu testing performed to assess the liquefaction potential of a sand formation at a site for a proposed large industrial facility in East Central...
A Relationship Between Deformation Modulus and SPT N for Gravels
The results of over 200 horizontal plate load tests performed in situ in large diameter boreholes on gravels at various relative densities are used to develop a relationship between deformation...
The Use of Cone Penetrometer Testing to Investigate Sand Fill Subsidence Beneath Highways
During construction of Interstate I-10 between Baton Rouge and LaPlace, Louisiana, highly organic swamp deposits were excavated and replaced with hydraulically pumped river sand. The main...
Effctive Stress Interpretation of In-situ Tests
Significant differences in terms of load-settlement curves obtained from Plate Load Tests (PLT) and q//c profiles obtained from Static Cone Penetration Tests (SCPT) at two sites with different...
Fast, Economical, Cone Testing of River Sediments
The objective of the study reported was to obtain quantitative geotechnical information over many square miles of Hudson River bottom. A hand held cone penetrometer was selected for use....
Comparison Between In-Situ Test Results
Penetration tests provide a means of obtaining data from which estimations can be made of the bearing capacity, settlement and liquefaction potential of the soils tested. Empirical formulae...
North American Standard Penetration Test Practice: An Essay
The Standard Penetration Test (SPT) is the in situ mechanical soil test most used by North American geotechnical practitioners. The equipment and procedures of the test have periodically...
Use of Piezometer Cone Data
The piezometer cone is generally regarded as the most efficient tool for stratigraphic logging of soft soils. A thin pore pressure element (5 mm thick) can sense layers a few centimeters...
CPT Indexing of In Situ OCR in Clays
Cone penetration tests may be used to index the in situ preconsolidation pressure in clay deposits. A specified relationship between C//u/ sigma //vo and the overconsolidation ratio (OCR)...
Lateral Stress Measurement During Cone Penetration
A lateral stress sensing cone penetrometer (LSSCP) was designed and fabricated. Based on the results of calibration chamber tests in sand, relationships between measured lateral stress,...
Determining Soil Properties by Electric Cone Penetrometer
Gravel island construction is one primary means of establishing permanent locations for oil wells, building foundations and road beds in the arctic. The gravel provides a natural insulation...
Soil Strength Determinations from the Cone Penetrometer Test
Geotechnical exploration in offshore Arctic regions often relies upon the electric Cone Penetrometer Test (CPT) because of its speed, economy, data continuity, and general reliability....
Arctic Penetration Test Systems
Geotechnical exploration in offshore arctic regions relies upon the electric Cone Penetrometer Test (CPT) because of its speed, economy, data continuity, and general reliability. By adding...
The Rapid Deployment System: A Method for Conducting In Situ Soil Tests from Moving Ice in The Arctic Offshore
A new system was developed which permits rapid helicopter assisted transport of a light-weight in situ geotechnical testing system to remote offshore sites situated on unstable first-year...
Seismic CPT to Measure In-Situ Shear Wave Velocity
A new test, called the seismic cone penetration test (SCPT) is described. A small rugged velocity seismometer has been incorporated into an electronic cone penetrometer. The combination...
Measurement and Use of Shear Wave Velocity for Evaluating Dynamic Soil Properties
Geotechnical engineers have recognized in the past decade that shear wave velocity is a basic soil property and have begun to use it to characterize sites for many uses. Most notable has...
Coefficient of Variation of In Situ Tests in Sand
For a research project on the behavior of piles in sand for the United States Geological Survey and the Federal Highway Administration, ten sites were selected where detailed load tests...
The Simple-Pile Approach to Pile Installation in Clays
This article describes the fundamentals of the approach and presents solutions for the effects of quasi-static deep undrained penetration of a simple solid pile on the deformations and...
Cone Penetration Testing and Experience
Experiences and advances in cone penetration testing are reviewed in these papers presented in a technical session at the National Convention of the American Society of Civil Engineers....
Return to search