Hurricane Andrew in South Florida: Preparing a Water Management System for Disaster
This paper analyzes Hurricane Andrew from its beginning as a tropical storm to the powerful force that it later became. The careful monitoring that took place throughout its transformation...
Computational Hydraulics?The Systems Approach
This paper introduces two modern computational hydraulic computer programs that combine the calculated subcritical and supercritical water surface profiles and pressure gradients in open...
Top Width of Pier Scour Holes in Free and Pressure Flow
The maximum top width of the local scour holes at piers is shown to be a simple function of the scour depth and the angle of repose of the bed material in water. Knowledge of the top width...
Preliminary Studies of Pressure Flow Scour
Bridges that become inundated during floods have slightly pressurized flow that impacts bridge piers and creates an aggravated scour condition. Results of two preliminary laboratory studies...
Pressure Relief Under Hydraulic Jump Stilling Basins
Gravity drainage cannot be used for any portion of a structure located below tailwater level. Yet, drainage of this area may be required to relieve sub-floor pressures and reduce the risk...
Friction Loss Equations for Hydropower Facilities
Many water suppliers are pursuing economic benefits from water supply and distribution systems through development of hydropower facilities on pipelines. Excessive pressure head that used...
Hydraulic Modeling of High Unit Discharge Energy Dissipators
The incorporation of an efficient and economical energy dissipation device is critical with respect to the safe operation of a high unit discharge spillway. The development and design...
Determination of Pulsating Pressures for Baldhill Dam, N.D. Spillway
Model tests of the existing Baldhill Spillway were conducted with symmetrical and asymmetrical gate openings to determine for various flow conditions the characteristics of the hydraulic...
Sliplining: Design and Installation Considerations for Polyethylene Pipe
The design methodology and installation procedure for polyethylene slipline renewal are discussed. When designing there are two critical phases which must be considered: (1) short-term...
Structural Design on Ductile Iron Pipe
The thickness class designation for Ductile Iron pipe has been changed to a pressure class designation in the 1991 revision of the C150/A21.50 ANSI standard. However, the same conservative...
Reinforced and Prestressed Concrete Pressure Pipe Diagnosis
Prestressed and reinforced concrete steel cylinder pipes are used for transmission mains, water intake lines, sewers force mains. Many collapses caused by the steel cylinder attack were...
Selection and use of Pipeline Leak Detection Methods for Liability Management into the 21st Century
Pipeline leak detection systems have been in use for many years on all types of pipelines with various products being transported. Pipeline owners and operators are subject to stringent...
Relocating a 54-Inch Diameter Force Main without Interrupting Wastewater Flow
The City of Tampa, Florida, was faced with the challenge of relocating three segments of an old 1372 mm (54-in.) diameter reinforced concrete pipe force main, totaling nearly a mile in...
The Load Factor
Spangler's load-factor formula for projecting conduits is generalized to all cases of buried rigid pipe, whether in trenches or under embankments; this is in accordance with the analytical...
Behavior of Suction Piles in Sand
In the marine environment, use of suction pressure for the installation of sealed top piles (suction piles) is a promising alternative to driven pile foundations, particularly in deep...
Transmitted Swelling Pressures on Retaining Structures
The main objectives of this paper are to describe a finite element model to simulate the lateral swelling behavior of expansive soils as a function of soil suction change in the soil domain...
Elasto-Plastic Volume Change of Unsaturated Compacted Clay
Isotropic compression tests were performed on samples of unsaturated compacted kaolin in a modified triaxial cell that allowed separate control of pore water pressure and pore air pressure....
One and Three Dimensional, Three Phase Deformation in Soil
An initially saturated soil exhibits two distinct deformation patterns as it drys. First, it deforms vertically until the soil begins to drain. Secondly , it deforms laterally as well...
Slip-Lining Solution
Grouting the annular space between a corroded sewer pipe and newly installed liner pipe is a stage of a typical sewer line rehabilitation project which contains hidden problems and difficulties....
A Design Manual for Coastal Fluidization Systems
This paper summarizes a recently completed design manual on fluidization systems to manage sand in the coastal environment for sand bypassing at inlets and harbor mouths and for creating...
Return to search