Runway Rehab: A Case for CADD
Hired to design and monitor construction at Boston's Logan Airport, engineers at S E A Consultant's quickly realized that they would have to supplement their...
Heavy Metal Accumulation in Subsurface, Estuarine Sediments and Inferences for Anthropogenic Enrichment: N.W. Florida Coast
In an attempt to quantify the degree of contamination and the thickness of the contaminated subsurface sedimentary wedge, approximately 100 samples were extracted from the cores and subjected...
Distribution of Flood Volumes Beyond Design Discharges
Quantitative prediction of flood volumes beyond design discharges is important for hydrologic design of river constructions, such as bridges and culverts, because these are the volumes...
Verification of the Princeton Transport Code (PTC)
The Princeton Transport Code (PTC) is a quasi-three dimensional groundwater flow and transport code. PTC is implemented using a splitting algorithm that allows the three-dimensional solution...
Structural Design on Ductile Iron Pipe
The thickness class designation for Ductile Iron pipe has been changed to a pressure class designation in the 1991 revision of the C150/A21.50 ANSI standard. However, the same conservative...
Using Neural Network to Identify Pavement Structure Based on Radar Output
Knowledge of asphaltic layer thickness and structure are important in many areas of pavement management. Accurate thickness and structure measurements are needed throughout the roadway...
Behavior of Instrumented Model Piers in Manufactured Rock with a Soft Layer
A laboratory test apparatus has been used to study the side resistance of piers socketed into manufactured soft-rock masses. The results of four tests are reported, three of which included...
Stability of Embankments over Weak Soils of Limited Thickness
Intermediate Level Waste Transport Shielding Study
Nonlinear Behavior of Thin Slender Free Surface Non-Newtonian Elliptical Rings
This paper analyzes the nonlinear motion of a slender concentric thin elliptical ring of an incompressible, non-Newtonian fluid. This study includes the physical effects of surface tension,...
The Small Mars Rover
Mars rover is one of the principal technical means intended for studying the surface of Mars. The first Mars rover was delivered to the Mars surface in 1971 and was designed for studying...
Analytical Prediction of Gasoline Thickness on the Water Table
With the increased use of immiscible fluid products such as gasoline, the threats to groundwater resources by hydrocarbon products are increasing. The success of recovery of the hydrocarbon...
Ice Jam Configuration: Second Generation Model
An early model of ice jam configuration in wide, prismatic channels is generalized for applications to natural streams. Test runs are carried out to illustrate model performance and study...
Major Results of Gravity and Magnetic Studies at Yucca Mountain, Nevada
About 4,000 gravity stations have been obtained at Yucca Mountain and vicinity since the beginning of radioactive-waste studies there in 1978. These data have been integrated with data...
Finite Element Approximation to Heat Transfer Through Construction Glass Blocks
The purpose of this study is to investigate the heat transfer through combined solid and fluid media, taking into account the interaction between the solid and the fluid. The main example...
A Contact Problem Modeling the Squeeze-Film Mode of Synovial Joint Lubrication
A contact problem modeling synovial joint lubrication under squeeze-film conditions is studied. In this model, the thin synovial fluid layer is incompressible and linearly viscous, and...
Spherical Shells with Nonuniform Rigidity
An iterative finite difference technique is presented in this paper for the analysis of axisymmetric spherical shells with variable wall thickness. The proposed method of solution is based...
Experiments on Stratified Flows: A Comparison with Theory
Stratified flows caused by salt wedges in estuaries, fjord flows and power station cooling waters represent very complicated flow situations with regard to their stability and rates of...
Standing Wave Measurements of Bedload Thickness: Feasibility in an Air System with Model Sediment
A novel technique would yield information about bedload thickness from measurements of a standing wave pattern produced by a sound source insonifying the bottom at normal incidence. The...
Influence of Hydrodynamics on Biofilm Accumulation
The influence of hydrodynamics on biofilm thickness was investigated under laminar and turbulent flow conditions. The maximum biofilm thickness was found within the transition region between...
Return to search