Calibration of Jackup Leg Foundation Model Using Full-Scale Structural Measurements
The fitness of jack-up rigs to operate in varying water depths and weather conditions is determined by "site-specific" structural assessments. These assessments are conducted by a wide range of companies...

Heave Compensated Landing System - A Novel Tool for Subsea Intervention
This paper presents a new intervention system that allows the use of a low cost workboat to deploy and recover delicate payloads in subsea installations. Vessel motions are decoupled from the subsea package...

Pipe Characteristics
Microtunneling pipe should meet the following general requirements: Circular shape with a flush outside surface (including at the joints); Strength sufficient to withstand both the installation...

Pipe Design
The pipes and joints, once installed, must be capable of safely withstanding, for the project design life, all in-use service loads, including those associated with the following factors:...

Performance Limits for Deepwater Pipelines
This paper highlights the differences between onshore and offshore pipeline design. It then summarizes the results of combined external pressure, tension, and bending testing on full scale...

Review of Climate Science for Engineering Practice
Weather and climate are a factor in civil engineering design and practice. Weather is defined as the state of the atmosphere with respect to wind, temperature, cloudiness, moisture, pressure,...

Dynamic Shearing Properties Of Compacted Clay
A series of 116 Q-type triaxial compression tests was performed using specimens of Goose Lake clay compacted at water contents ranging from 9 percent dry of optimum to 3 percent on the...

Estimation of Consolidation Properties of Clay from Field Observations
Analyses to obtain theoretical time-settlement curves for embankments typically make use of soil properties measured in the laboratory on small disturbed samples subject to strain rates...

Behaviour of Open-Ended Pipe Piles in Sand During Installation and Loading
An experimental study was performed to investigate the physical processes which influence the axial load capacities of open-ended steel pipe piles in sand. A double-walled pipe pile was...

Pore Water Pressures in Unsaturated Soils
Unsaturated soils are three-phase systems composed of solid mineral matter, water, and air. Such soils may be formed by either natural or artificial means. Except in moist environments,...

Pile-Driving Formulas for Friction Piles in Sand
Dynamic pile-driving formulas are widely used in predicting the load-carrying capacity of friction piles and in writing pile-driving specifications. Further, when load tests are available,...

Design and Installation of Auger Steel Catenary Risers
The Auger export pipelines are connected to the TLP by steel catenary risers (SCRs). This is believed to be the first time steel pipe has been used for catenary risers. SCRs offer advantages...

Dynamic Response of the Hood-Canal Floating Bridge

Dynamic Response of Floating Bridge to Wave Forces

Development and Use of Force Pulse Train Generators

A Rectilinear Force Generator For Full Scale Vibration Testing

Hybrid Modelling of Seismic Structure Interaction

A Fault-Rupture Propagation Model for Ground Motion Simulation

Measurements of On-Site Dynamic Parameters for Seismic Evaluations

Calculated Examples of Long-Span Bridge Response to Wind

 

 

 

 

Return to search