Turbulent Velocities in a Mountain River
A weighted, electronic Pitot tube was deployed in the swift, boulder-bed Waiho river during a 46 m3/s flow and a 214 m3/s...
Hydraulics and Sediment Transport Processes in a Pool-Riffle Rocky Mountain Stream
Sediment transport processes related to varying channel-bed morphology were investigated from April to November, 1993 along a 1 km pool-riffle and step-pool reach of North Saint Vrain...
On Habitat Simulation in Mountain Rivers
Mountain rivers are quite different from other rivers and one of the characteristics that distinguish them from others is the large variation in velocities with time, with location in...
Coarse Sediment Transport and the Maintenance of Fish Habitat in the Upper Colorado River
An analysis of the relation between discharge and boundary shear stress is presented for an alluvial reach of the Colorado River near Grand Junction, CO. The analysis indicates that the...
Palaeohydraulic reconstruction of floods in upland UK bedrock streams: progress, problems and prospects
Palaeoflood evidence from five small upland Pennine catchments in the UK is used with the HEC-2 flow routine to simulate Holocene peak discharges. Even allowing for uncertainty, sensitivity...
Streamflow Related to Channel Geometry in Northern New England
Channel geometry measurements can be used to estimate various streamflow characteristics at ungaged stream locations. Channel cross section dimensions and sediment size distributions were...
Historic-Flood Evaluation and Research Needs in Mountainous Areas
An evaluation of historic flood estimates in mountainous areas in Colorado was made to assess their accuracy. The purpose of this evaluation is to enhance awareness of the need to assess...
PSF-PM Verification of 3D Free Surface Flow Models
This paper reports an application of the Prescribed Solution Forcing (PSF) and Physical Modeling (PM) to the development of a systematic procedure for the verification of three-dimensional...
3D Free Surface Flow Model Verification - A Panel Discussion on Test Cases
This paper is to briefly present the objectives and approaches of the Panel Discussion on test cases to be developed for 3d free surface flow model verifications, so that professionals...
Velocity Control Rings for RC Pipe on Steep Slopes
This paper discusses the use of internal concrete rings to reduce velocity and concrete erosion for reinforced concrete pipes on steep slopes in the Southern California area....
A Physically-Based Model of Channel Widening
The application of many existing models of river channel morphology is limited by their inability to account for bank erosion and changing channel width through time. This paper outlines...
Theoretically-Derived Regime River Width
The governing equations describing the motion of fluid and non-cohesive sediment particles in alluvial channels are combined to analytically determine the equilibrium surface width of...
Boundary Shear in the Vicinity of River Banks
Some experimental data are presented concerning the distribution of boundary shear stresses in trapezoidal open channels for both inbank and overbank flows. The local shear stresses on...
Expansion and Contraction of Powder River Between Moorhead and Broadus, MT: Geomorphic Observations and Numerical Modeling
Sixteen years of annual surveys demonstrate that the channel of Powder River expands at high flows and contracts at low flows. Channel contraction is associated with the formation of benches...
Air Entrainment and Bubble Behavior in Plunge Pools
This study analyzes air entrainment by falling nappes and bubble behavior in plunge pools, using an experimental-analytical-numerical method. The experimental work was done at the Tennessee...
Macro-Roughness Effects on Stream Reaeration
The gas transfer coefficient is key to modeling dissolved oxygen levels in streams. Engineers commonly predict it as a function of mean flow depth, velocity, and slope. Large errors are...
Air Concentration Measurements in Highly-Turbulent Flow on a Steeply-Sloping Chute
The U.S. Bureau of Reclamation's (Reclamation) stepped spillway overtopping protection research program required air concentration profile data be obtained during testing in a large, 15.2-m-high...
Luo, Ming
The algebraic stress model of turbulence is employed to calculate the 2-D flow field of the Gongzhui reservoir region. The discharge distribution among the discharging structures is achieved...
Reservoir Sediment Removal: Hydrosuction Dredging
Hydrosuction dredging is a relatively little-known method of removing sediment deposits from reservoirs. The method is similar to traditional hydraulic dredging except the difference between...
Multi-Reservoir System Simulation Design Using C++ and Object Oriented Programming
Scientists and Engineers intuitively perceive the world as objects with interactions and internal processes. Physicists may view there work as different particles exerting forces on each...
Return to search